Home > Fax Error > Fax Error 388 Hp Officejet

Fax Error 388 Hp Officejet

Contents

Ask the sender what speed the fax machine is using to send, and then reconfigure the local machine to receive at that speed, if possible. An error code can have more than one definition (cause), and more than one solution. Configure the remote machine for reception. Generated Wed, 23 Nov 2016 18:24:50 GMT by s_wx1194 (squid/3.5.20) Source

NOTE: If errors occur every time a fax is sent or received, go to Troubleshooting Fax Transmission and Reception Issues . The paper is not correctly loaded and the document sensor cannot sense it. Solution Retry the fax reception at a different time when telephone line conditions have improved. This error is very rare because normally a remote machine does not answer if it cannot receive a document.

Fax Error 388 Hp Officejet

Make sure paper is loaded correctly, paper is not jammed within the machine, and any other system errors have been cleared. 232 233 234 235 ECM 236 ECM 237 A communication Also make sure the remote machine is attempting to initiate a transmission and not a reception. 243 244 The user of the remote machine pressed the Stop key, causing the session The remote machine disconnected immediately before sending any further fax tones or T.30 frames. Resend at a lower resolution.

i just reduced my line speed.to do the "REDUCED" line speed, I went to ADVANCED FAX SETTINGs in my menu and choose LINE SPEED. Configure the local fax machine to use a slower reception speed. Whatever I send thought just sits in queue.? Fax Error 346 Retry the transmission.

Please try the request again. Hp Fax Error 345 Reply 0 Reply 0 0 kawaii_aoi Master's Graduate Posts: 368 Member Since: ‎09-10-2011 Message 2 of 4 (8,237 Views) Report Inappropriate Content Re: Error 388 appears when I try to fax. We can't fax. http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-buu02549 Configure the remote machine for document reception by clearing any paper jams, loading sufficient paper, and clearing any other error messages.

Error Code(s) Definitions/Causes Solutions 300 The fax session completed without errors. Error 388 Hp Officejet 4500 Question about FAX 1250 Fax Machine (Black) 1 Answer Error code 388 Error Code: 386, 387, 388, 389, 390, 391, 392, 393, 394, 395 Definition There is too much noise on If the problem persists, the tech people at the TweakHomePC website have some suggestions for isolating line noise for modems, but the same tips can apply for fax machines. Retry the fax reception when telephone line conditions have improved.

Hp Fax Error 345

If I helped you at all it would be great if you clicked the blue kudos star!If I solved your post please mark it as solved to help others.I'm a printer It tells you all the errors. Fax Error 388 Hp Officejet Reconfigure the local fax machine to use different configuration settings, enable or disable the ECM setting. 245 ECM 246 ECM The user of the remote machine pressed the Stop key, causing Hp Fax Error 344 Reply 0 0 Kyle_W Distinguished Professor Posts: 4,755 Member Since: ‎04-26-2011 Message 3 of 7 (13,016 Views) Report Inappropriate Content Re: i am trying to fax but received a message with

Specifically, fax tones or the fax handshake (connection) from the remote machine was not detected. this contact form Ask the remote machine user to reset the remote machine. Subsequent page transmission can still occur and later pages can be received without error. Select a slower reception speed. Error 388 Hp Officejet 6700

If faxes are successfully sent to and received from other machines, but not this particular remote machine, then the issue is probably a problem with the remote machine. 252 Telephone line Try sending the fax again. 312 A remote fax machine failed to answer the call. I have tested it and am able to receive faxes but get error 388 when I try to send out a fax. have a peek here Disable V.34 on the local machine and attempt the transmission using the V.17 mode. ( See error 227 for changing to a slower speed or disabling V.34 .) http://h20000.www2.hp.com/bizsupport/Tec...

Everything should pass.Turn ECM Off - Setup > Fax Menu > Advanced Fax Settings > Error Correction Mode > OffFax Speed - Setup > Fax Menu > Advanced Fax Settings > Hp Fax Error 350 The noise problem might go ... Reply 0 Fax error code 388 - how to resolve 01-22-2013 11:59 AM @UteMtnI would take a look at the document below it describes what every fax error code means.

Family Lines: HP OfficeJet HP LaserJet HP PhotoSmart Brands: HP Brother Sharp Xerox Categories: Printers & Copiers Computer Utilities & Maintenance Fax Machines Unanswered Questions Ask a Question Usually answered in

Ask the remote machine user to send at a lower resolution setting. Are your Ink Cartridges low? Source(s): www.hp.com -- search for your product in troubleshooting! Hp Fax Error 358 Reply 0 0 Earlybird455 Student Posts: 1 Member Since: ‎11-19-2011 Message 3 of 4 (8,193 Views) Report Inappropriate Content Re: Error 388 appears when I try to fax.

Contact the remote caller and have the fax sent again. 222 The local machine answered a call, but is unable to detect the presence of a calling fax machine. Reply 0 0 JP64 Honor Student Posts: 2 Member Since: ‎11-16-2015 Message 7 of 7 (4,653 Views) Report Inappropriate Content Re: i am trying to fax but received a message with No action required. 311 The user of the local machine pressed the Stop key, causing the session to be prematurely terminated before all pages have been sent. Check This Out If you want remote polling, confirm that you have correctly configured the local machine for poll transmission. 229 The remote machine attempted to initiate a secure poll transmission from the local

Question about PSC 2410 All-In-One InkJet Printer 1 Answer Hp laser jet m1536dnf MFP won't send fax comm error 388 ...fax comm error 388 new printer and we can't send out Fax log said result error 388. Wait five or ten minutes and try your fax again. Do not use call waiting on a line with a fax machine.

The user called the correct number, but the machine was configured not to answer. First Time Here? Depending on your printer, a fax error code might display on the printer control panel or on a fax history report. Poll transmission from a remote machine is typically configured with each fax session.

Retry the fax reception when telephone line conditions have improved. Try the fax when telephone line conditions have improved. Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video, i get script error n it wont let me message them?

Retry the fax reception when telephone line conditions have improved. Try to receive the fax when telephone line conditions have improved. Retry the fax transmission when the line is no longer busy. 314 The local machine attempted to initiate a remote diagnostic session, but detected that remote diagnostics are disabled on the However, the ability to send the entire document improves.

The local machine held the remote machine during reception of a large or complex document due to lack of available memory.